By A Mystery Man Writer
The old cabinet pins were to short, so I printed some new ones
3d printed a small „pocket organizer“. Parts fit snug and do not
Pocket Screwdriver in Carbon Fiber PETG : r/functionalprint
TaylorMade Portlight Hinge Assembly printed in PETG : r
Router Guide : r/functionalprint
Recessed light install helper : r/functionalprint
Component tester block : r/functionalprint
Skadis holder for the LTT/Megapro screwdriver and Pocket bit case
My Pocket-Go V1 was hurting my hands after using it for a while
Printed Grommet to keep wires from getting cut : r/functionalprint
Hardhat mount for Milwaukee pocket rover light. : r/functionalprint
My Altoid EDC : r/functionalprint
Some stuff I printed the last few weeks : r/functionalprint